Engraving an AR receiver

[KennethConnell1]

here is a video of the program in action.
https://www.youtube.com/watch?v=Z59BkvBOx5A

and here is a link from an older post on the subject.

Carving uneven stock/material

yes it will work with the X-Controller. that is what I have. I personally liked Bcnc as the program runs from the local machine and although chilipeppr works nice it is browser based and I never liked some of the limitations of the browser, i.e. larger file support. when I did the AR which is aluminum I did not need to use the tape method. but I did see a video in which a person used the aluminum tape to touch off of. just ground the tape with one wire and hook the other to the bit “same …