G-code Import issue & questions

I am trying to follow your instructions in downloading the Easel post-processor for Vectric. I have downloaded it into my download folder but your instructions state to “Copy the downloaded post-processor into the PostP folder.”. I cannot locate any “PostP” folder in any of the Easel files I have in my computer. Where would I find such a folder?

Next question:

If I post the toolpaths from Vectric using the V-Carve Post Processor that they have in their software, do I even need to run it through the Easel post-processor?

the post-processor for xcarve is already available post Prosser list in Vectric software .

If your already using verric, then I would move on to a better gcode sender. Check out openbujlds control or UGS

This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.