I need to make this sign and hang it on my work table in the garage. Tonight could have been a disaster. Luckily, the second bit was only about 1/8" further out than the first, so while it ruined the piece, it wasn’t too dangerous!
3 Likes
Been there, done that!
I’m looking to change the message that pops up when a tool change is done to something like"
Hey Stupid! Zero your z-axis!
[I run Linuxcnc, not grbl]
1 Like
I think everyone needs one of these. lol
Yup! Need that too. In lieu of a sign, I have a step by step checklist that I force myself to follow for every project now.
I’m not THAT forgetful… thank god!!!
n noggin!
1 Like