Increasing plunge rate, BIGLY

So, it looks like within the Cut Settings, the Plunge Rate is set to 36 in/min for most projects, under the Automatic tab.

Seems to me like plunging is one of the less stressful cuts for the XPRO, if I’m doing just straight cuts with pockets. Each item I’m cutting out has 6 tabs, so there’s a lot of up and down, on the Z.

So, I’ve increased that speed to 80 in/min. Seems to run great, and speeds up the project.

I’m new to this machine, so I’m asking if anyone sees any problems in my future?