I’m attempting to cut a face at an angle from a sheet of 12mm plywood using an 8mm end mill. I realise that this is not the best cutter to use for the job but for what I want it should produce a good enough cut. The problem I have is defining a toolpath that will cut beyond the boundary of the mode…

My Account

Log Out

Machine path for angled cut in Fusion360

NeilFerreri1 February 19, 2020, 5:26pm 6

Start by drawing a rectangle on your part that includes your slope + half the end mill.

Change your Geometry settings in CAM to use your newly created rectangle. Center on boundary for tool containment.

That should be it!