Mike here. I have the X-Carve 1000mm with the full upgrade kit. I’m stuck at the “Attach Smooth Idler Wheels” section. I spoke with someone at support last week, but what he suggested went right out of mind after hanging up with him. The pictures of the assembly of the smooth idler wheels show a level of the build I am nowhere near, so I’m not able to make heads or tails of the steps. Does anyone have any suggestions on available videos to watch on making the jump from where I am in the process to where I need to go?
As an aside, I knew before ordering that Inventables tech people had not yet completed instructions for someone in my shoes. If I understood what the process would have entailed, I would have waited to buy until after full instructions were ready.