Normal for a 90* v-bit?

[RussellCrawford]

@DuaneHeda

I would have to seal the whole carve and not just the carved area right?

Yes, seal the whole piece first.

I did this awhile back but it goes through the process I use.
Most people use (blue) Oramask 813, I use (Gray) Oramask 810 because if conforms to curves better.
I used Shellac on plywood and I use Varathane sanding sealer on MDF.

A few projects that I have made

Some signs I made using plywood, Oracal 810 masking, shellac and rustoleum spray paint. I sanded the board and applied shellac Sanded and sprayed a coat of paint Sanded and sprayed 2nd coat Let dry and applied vinyl masking Engrave Apply shellac to engraved wood Spray paint Remove mask I have used the oramask 810 a few times and it has worked good. I used a 90 degree Diablo bit from HD [241542B2-4F09-40C5-A8B3-87845064FD8F][0A8B65DB-C907-4F4A-99D0-8A66188930B2][977A3F33-72D3-41A4-ABD4…

Edit:Click on the link that says A few projects that I have made

Russell