Raised text sign

When doing raised text like 2 layer what do I set my cut path at. Example :Welcome Home.With home on top
Cut depth I have done but for some reason my machine is testing my patience.

If you set the, “Home”, cut depth to 0 and the, “Welcome”, cut depth to something below that, Home will be on top.

1 Like

do i have to set the initial retangle to a depth or just leave it

1 Like

The rectangle would need to be set to the back and it would also need a depth.
I usually do 1mm for the text, and 2mm (1mm deeper) for the rectangle.

Thank you I will try again. Tried twice but deal, what is the cut path set at

Worked ok this time but my detail bit should have been other than a v bit. Wasn’t quite finished

1 Like

This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.