Settings for 1000mm X-Carve with TinyG and ChiliPepper

I am going to be running my 1000 mm X-Carve off a TinyG (hardware version 8, firmware 0.97) using ChiliPepper to control it. Has anyone else already dialed theirs in with this configuration that would be willing to post their settings in ChiliPepper?

I’ve got the same intent. TinyG with ChiliPeppr. Not done wiring though.

Just ordered a Due from eBay to test out TinyG so awaiting eagerly for any updates on this post. @makermark - hope you post yours if you have figured it all out!

Hey Mark, there is hangout tonight. Those guys know everything. Here is the link If you want to jump in.