Sooooo lost

[BrandonR_Parker]

Are you using 1/4" for Roughing and 1/8" for Finish?

Are you moving the gantry when changing the bit? Check your settings by going to the Machine Inspector and type in $$. Check what $1 is set to. It should be set to 255.

Do you have the X-Controller? If so, have you set the internal dip switches correctly? Check out the post below.

Multiple depth carve

Do you have the X-Controller? If you do, you should open it up and check the Dip Switches for each axis. Dip Switch 4 should be set to the OFF (Down if viewed with numbers on bottom or left in the image as shown) position as shown in the image below. [Capture] You will also need to ensure that parameter $1 in the GRBL settings is set to 255. [Capture] {:0) Brandon Parker

Is it consistently the same offset? Does the machine return to the original Work Home position? Have you attempted to perform a single bit air carve to see if the machine returns to the original Work Home position?

{:0)

Brandon Parker