I honestly don’t know what G28 is (and understand it marginally more after reading this post: Learning About G28) so I doubt that I have turned off (or turned on) G28. I know that I didn’t do it before any of my successful carves, either.
I have not rebooted my computer (and I will feel like a dumb-a$$ if that is what it is since that’s the first thing tech support says for anything!)
I did run the simulation in fusion, and it followed the paths that you see in the image above.
I think I understand (from the above referenced post) how to turn G28 off - I can go check that and then also reboot the computer. That would be great if that’s all that my issues were, but it would also make me think that I should just quit! 