Way too long simulation time

[HaldorLonningdal]

Read through this thread, it should help you on your way

Monogram / Door Hanger / Fatten Type

I get a lot of questions on how to do this, see pictures below. Fatten Type You can use the Offsetter app to Fatten type. After you fatten it select all and fill. Then you will need to set the areas to either full depth or zero depth and then re-combine [1] Monogram / Door Hanger Remember once you set your outline you can control it somewhat on how it cuts by choosing, inside, outside or on path. Tabs are your friend with these I use one to two of them in every waste area. [IMG_3262] [IMG…

(Reason your carve estimate is 38hrs is due to large portions of material to be carved which is not needed if only a cut-out is required)