X-carve 500x500 mm, cut large pieces

[EmilianoMolina]

In F360 there is an option for each ‘setup’ where you can define the home point for the operations.

You can see it being used in this thread where we talk about the Work Co-ordinate System. You can also see the relevant option in the screenshots.

Fusion 360, and tool orientation problem

Here’s an example. This a g-code imported to easel before this started. [image] You can see that the tool started at the home position, then moves and makes the cuts, then returns to home. [image] And here is g-code imported after this started happening. You can see that the tool path begins at the home position. [image] This is an image of the above part. I set the home position to the lower left corner, but the tool dose mot move from home position. It just goes strait down and star…