Z-axis v-wheel bearing clicks in and out

X-Carve
1

I think I have an issue with one or more of my original z-axis v-wheel bearings. I have been noticing some run out on some corners and such and don’t push the machine much past the pre-sets in easel.

I thought I read somewhere that some of the bearings were bad and didn’t seat correctly, or had bad washers.

Can we order replacements that will be correct.

2

I had the same problem with my v-wheels. I replaced the washers for less than a dollar at home depot and have not had any problems since. Take a look at this thread: V-wheel "indenting" - #20 by AlanDavis