Aspect ratios using Easel

[HaldorLonningdal]

@TonyDeane

I have run 2 cuts of 100mm, X & Y, the X cut is accurate, producing a line of 100mm but the Y cut is only 65mm. Of course that is known hence why I am getting squashed cuts and that not WYSIWYG given that I have drawn to scale on Easel?

Obviously until I can resolve this issue…

You need to change your step per millimeter value under the GRBL settings of your controller.
Check - Steps/mm Calibration
This is an easy task to perform and get dialed in. If not, ask