Chattering While Milling Aluminum

[HaldorLonningdal]

This is mine and its journey, started with no clue and made this into a learning experience where cheap and DIY was the main criteria:

My DIY-carve

I have been active for some time on this board but have not had any decent images to show for until now - so now I wanted to share my simple project. A year or so ago I knew nothing about CNC / machining. The Carve is DIY and I have had a low cost approach, the only real money going into this have been the SBR16 railing, ACME T8 rods, Nema23´s and Makita router. The rest is wood/parts I had on hand already. This is actually v2, v1 used drawer slides for Y-axis - which worked surprisingly wel…

EliasPolitis make some good points on the correlation of feed/depth/speeds in there as well that is worth digging into.

(I am still learning btw haha!)