Extremely frustrated with my machine

[AlanDavis]

Zipped doesn’t mean properly tight.
You may follow this link. Also very similar threads on the forum.

Procedure to Set Belt Tension

I’m finishing up the assembly of my X-Carve, and have no idea what kind of tension I should have on the belts. I picked up a little fish scale on Amazon and made the following procedure: On belt of concern, run the carriage or gantry all the way to the “secure” side of the belt (the non-adjusting end). Zero scale/tension gauge and hook under belt in middle of belt. With one hand holding a small ruler, pull up with the scale until the belt has been pulled up to the 1 inch mark, then read the g…

And this link for Wheel problems.

Should V-wheels have side to side play in the bearing?

Because my machine is still not assembled I spent about 4 hours measuring the V wheels I received. First thing I did was make up a go no go plug that fits the wheel bore. Then using a depth micrometer I measured from the top of the wheel down to the plug and then from the top of the wheel down to the top of the center rib. By subtracting one for the other I got the width of the center rib that according to the drawing I downloaded from Inventables. Drawing says rib should be 1.0mm +.0 -.08. so …