Randy's first carve

(Hope this is the appropriate category)

Just did my first carve, and in my novice opinion, it did well. Due to the deep cuts and the material being MDF some small pieces broke off (like the small triangle at the point of the easel) but, overall, I think it is a success. And, honestly, I am quite stoked.


Thanks. A warm welcome is felt. Now to start learning some software… Bwuhahahaa


Congratulations and welcome to the group


Welcome Randy…

Cuts looking good… You might want to try this as well

Here is the link to the discussion … Calibration Test Procedure

Welcome and get carvin’!!!

I saw that awhile back when I was a new lurker. Thanks…I will give it a shot.

Get carving… next merit badge is for breaking a bit

1 Like

Awwww I missed that one. Knock on wood, I have yet to breath a bit…lol