UGS and Firmware Update

Is anyone else having troubles using UGS since the firmware update? UGS is saying either “cannot stream with active commands (controller)” or stops after 15 lines. I am using UGS for laser sending. I did not have these issues prior to updating to the newest firmware. Thank you.

Look here:

Thank you @LarryM. I was browsing the update category and didn’t go to the troubleshooting. I will give this a shot

1 Like

This worked @LarryM. I appreciate the help! I was worried there for about 30 minutes trying to get the 2 programs to talk to one another.

1 Like