Upgrading to LinuxCNC and SaveBase China Controller

[DanMyers]

Kind of guessing on some of these initial settings, but I did download a config file off here that got me started.

Anyone got a LinuxCNC config for x-Carve?

@EvanSmith Yes, I have Linuxcnc configured and working on the X-Carve. I did have to change from the IBM Think-center that I was going to use as it’s latency figures were bad. I ended using a HP system of about the same vintage which gave excellent results. I’m running Linuxcnc 2.7.3 (the latest) on Ubuntu 12.04.5 LTS. It’s running a Gecko G540 with the A axis slaved for the second Y axis motor. Motor direction may differ depending on how your motors are wired. Home switches are wired normall…

If anybody has an idea of initial values on this config screen it’s much appreciated. China spec sheet was sorely lacking

Was able to do some x axis testing and not sure I have it right, but it’s crazy fun to play around.